Filter
Top Products
[ 9 ]
GETTING STARTED
C. Connect the base unit
1 Connect the AC adapter to the DC IN 9V
jack and to a standard 120V AC wall outlet.
2 Set the base on a desk or tabletop, and
place the handset on the base unit as
shown. Remove the beltclip, if attached,
for face up charging. (See “Mounting the
Base Unit on a Wall”, on page 11.)
3 Then raise the antenna to a vertical
position.
4 Make sure that the status LED lights. If the LED does not
light, check to see that the AC adapter is plugged in and
that the handset makes good contact with the base
charging contacts.
• After installing the battery pack in the handset, charge
your handset at least 15-20 hours before plugging into
the phone line. Once the handset battery pack is fully
charged, connect the telephone line cord to the base and
telephone wall outlet.
5 Connect the telephone line cord to the TEL
LINE jack and to a telephone outlet once
the handset is fully charged.
The handset can be
placed up or face
down in the base for
charging.
GETTING STARTED
•Use only the supplied AD-313 AC adapter. Do not use any other AC adapter.
•Connect the AC adapter to a continuous power supply.
•Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
Place the power cord
so that it does not
create a trip hazard
or where it could
become chafed and
create a fire or
electrical hazard.
If your telephone outlet isn't modular, contact your telephone company
for assistance.
TRU548 ENG O/M 7/18/01 15:39 Page 9