Filter
Top Products
BASICS
[ 19 ]
BASICS
• Only the last number
dialed can be accessed
after has been
pressed.
• The tone feature only
applies when the dial
mode is set to pulse.
Redial from Talk Mode
1 Press .
“
Talk” and the volume setting appears on the display.
2 Press .
The last number dialed will be displayed and redialed.
3 To hang up, press or place the handset on the base. The call-time will
be displayed for about 5 seconds.
If you set the ringer to off, “<Ringer Off>” appears
on the display.
Some telephone companies use equipment that require
pulse dialing (sometimes referred to as rotary dialing). If
you need to enter tone dialing digits, you can switch-over
to tone dialing during the call. An example of this could
be entering your bank account number after you have called your bank. The
digits of your bank account can be sent using DTMF tones.
Initially make your call with the pulse dialing mode. Once your call connects,
press . Enter the desired number (like in the example above, the
bank account number). These digits will be sent as tone dialing. This special
number can be stored in a memory location. This is referred to as Chain
Dialing (See page 27). Once the call ends, the tone mode is canceled and
pulse dialing mode resumes.
Tone Dialing Switch-over
TRU548 ENG O/M 7/18/01 15:40 Page 19