Filter
Top Products
[20]
BASE SETUP
Name Tag
Name Tagging works with the Caller ID. You will need to subscribe to the Caller ID feature with your phone
company for Name Tagging to work.
When the phone rings, the received caller display number is compared to numbers stored in the phonebook.
If there is a match then any name stored with the phonebook number will be displayed. To change the Name
Tagging setting, follow the steps listed below.
1) Press
[menu/set]
on the base or
[menu]
on the handset.
2) Press
[select/▼]
on the base or
[volume/ /
-
]
on the handset to move the pointer to select NAME TAG.
If you set from the base, press
[menu/set]
on the base.
3) Press
[select/▲]
or
[select/▼]
on the base or
[select/intercom]
on the handset to select ON or OFF.
4) Press
[menu/set]
on the base. You will hear a confi rmation tone or press
[menu]
on the handset to
complete the setting.
Insert 0
This feature adds “0” or “00” at the beginning of the number received from Caller ID. The default setting for
New Zealand is ON. The default setting for Australia is OFF. To change the Insert 0 setting, follow the steps
listed below.
1) Press
[menu/set]
on the base or
[menu]
on the handset.
2) Press
[select/▼]
on the base or
[volume/ /
-
]
on the handset to move the pointer to select INSERT 0. If
you set from the base, press
[menu/set]
on the base.
3) Press
[select/▲]
or
[select/▼]
on the base or
[select/intercom]
on the handset to select ON or OFF.
4) Press
[menu/set]
on the base. You will hear a confi rmation tone or press
[menu]
on the handset to
complete the setting.
BASE SETUP
SSE17+1 OM.indb 20SSE17+1 OM.indb 20 15/7/08 12:08:31 PM15/7/08 12:08:31 PM