Filter
Top Products
5
Installing the Repeater/Charger(s) (if included)
Connect the repeater/charger power cord
1. If your phone came with any
accessory handsets and chargers,
connect a charger AC adapter to
each charger's
DC IN 9V
jack and
set the plug into the notch as
shown. (These adapters might
already be connected.)
Plug the other end of the adapter 2.
into a standard 240V AC power
outlet.
Aach the stand
To attach the stand, you have to decide if you want the repeater to 3.
rest on a desk or hang on a wall.
For desktop use, turn the stand so the locking tabs that say
DESK
are facing the base with the arrows pointing up.
OR
For wall mount use, turn the stand so the locking tabs that say
WALL
are facing the base with the arrows pointing down.
Align the stand with the notches on the repeater.4.
Slide the stand onto the notches until it clicks into place. (To 5.
remove the stand, pull the locking tabs up and back. Then, slide
the stand straight off the same direction you put it on.)
Place the repeater/charger on the wall
For wall mount use, place the mounting slots (hole spacing is 6.
30mm horizontal) over the pins on the wall, and slide the base
down to lock it into place.
To place a Repeater/Charger
Make sure you have a strong signal from the base (at least 3 bars x
in the handset display).
Put the charger at least 10m away from the base or any other
x
Repeater/Charger. (If you put the charger on a different floor from
the base, don't forget to allow 10m vertically, also.)
XDECT R035 OM.indd 5 22/9/11 1:50:59 PM