Filter
Top Products
16
the number keypad to enter 2 digits for the hour and 2 digits for the
minutes, e.g., 0530 for 5:30).
The Global Setup menu
The settings on this menu affect all handsets and the base. Before
changing these settings, make sure the phone is in standby and all
handsets are within range of the base. (Only one handset at a time can
change these settings.)
Set Line Mode
Do not change this setting unless instructed to by
customer service.
Insert 0
This feature adds “0” or “00” at the beginning of
the number received from Caller ID. The default
setting for New Zealand is ON. The default setting
for Australia is OFF.
VMWI Reset
Reset the message waiting indicator if it gets out of
sync with your voice mail service (see page 25).
How to enter text on your phone
Use the 12-key dial pad when you want to enter text into your phone
(a name in the phonebook, the handset banner, etc.).
The phone defaults to a capital letter for the first letter and any
x
letter after a space; otherwise, it uses small letters.
To switch to all capital letters, press
x
*
. The phone defaults to all
capital letters first (e. g. ABCabc2) until you enter a blank space or
press
*
again. (Any time you want to change case, just press
*
.)
If two letters in a row use the same number key, enter the first
x
letter and wait a few seconds (or press
RIGHT
); the cursor will
move to the next space. Enter the next letter.
Press
x
#
to enter a blank space.
To change a letter, move the cursor to that letter and press
x
CLEAR
to erase the letter; enter the new one.
To erase the entire entry, press and hold
x
CLEAR
.
Press
x
0
to cycle through all available symbols and punctuation.
XDECT R035 OM.indd 16 22/9/11 1:51:11 PM