Filter
Top Products
37
In about 30 seconds, the handset display should say
Registration
Complete
. Press
TALK/FLASH
and make sure you get a dial tone.
If... Try...
- you don’t hear a dial tone
- the display says Registration Failed
Making sure the handset is
fully charged, then starting
over at step 1.
Registering Repeaters
If you are having trouble with a repeater or if you want to replace one,
you need to register the repeater to the base.
TIP: Connect the repeater close to the base for easy access to the
necessary keys and indicators. Locate the repeater in the desired
position after registration is complete.
On the base, when the phone 1.
is in standby, press and hold
FIND
until you hear a long beep
from the base and the
DND
light
starts flashing.
On the bottom of the repeater 2.
you want to register, press and
hold the registration button
until the
LINK
light blinks
rapidly.
In about 90 seconds, the 3. LINK light on the
repeater will turn on. The repeater has been
registered to the base.
If the LINK light doesn't turn on, try these steps
again.
7
Each of these bases can support up to two DRX402 Ultra-
Range chargers, including any that were supplied with
your phone.
Usually, you can't tell when a handset switches between
the base and the charger in the middle of a call, but
sometimes, you might notice a brief pause in your
conversation.
Registering the Ultra-Range charger
Registering the Ultra-Range charger is a separate
process from registering the handset. You can use
the charger even if the handset is not registered.
On the base, open the menu and select
Register Handset
.
On the bottom of the Ultra-
Range charger, press and
hold the registration button
until the
LINk
light starts to
blink (about 2 seconds).
Release the button and wait
for the
LINk
light to turn on
and steady (this can take
about 90 seconds).
If the
LINk
light doesn't turn on,
disconnect the charger's AC adapter.
Wait about ten seconds, then try these
steps again.
Some important things to remember:
Only register one charger at a time. If more than one
charger is in registration mode at the same time, they can
interfere with each other.
If you want to use the Ultra-Range charger with a different
base, just register the charger to the new base. The
1.
2.
3.
XDECT R035 OM.indd 37 22/9/11 1:51:17 PM