Filter
Top Products
22
Finding a Lost Handset
With the phone in standby, press
FIND
on the base. All the handsets will
beep for 1 minute; to end the page, press
FIND
again or press any key
on any handset.
Using Mul-Handset Features
To use the features in this section, you must have at least two cordless
handsets.
Expanding your phone
Your base supports a total of six cordless handsets: the one that x
came with the base and up to five XDECT R003BT accessory
handsets.
Your base might be compatible with other Uniden accessory
x
handsets: please visit our website for a list of compatible handsets.
Accessory handsets must be registered to the base before you can
x
use them. Handsets that aren't registered display a
Handset not
registered
message. For instructions on registering handsets to
the base, see page 36, or consult the accessory handset manual.
Any accessory handsets that came packaged with the base are
x
already registered for you.
If a handset was previously registered to a base, you have to reset
x
it so you can register it to a new base (see page 36 or the manual
for the accessory handset).
Conference calling
When an outside call comes in on the land line, two handsets can x
join in a conference call with the outside caller.
To join an ongoing call, press
x
TALK/FLASH
or
SPEAKER
.
To leave the conference call, hang up normally; the other handset
x
remains connected to the call.
Privacy mode
You can prevent other handsets from joining a call. Start your call
as usual, then press
MENU/SELECT
: the display shows
Call Privacy
.
Press
MENU/SELECT
again to turn privacy mode on (you’ll see in the
display). When you hang up, privacy mode turns off automatically.
XDECT R035 OM.indd 22 22/9/11 1:51:13 PM