Filter
Top Products
20
To locate the handset when it is off the base, press on the base.
The handset beeps for 60 seconds. The following screen appears:
Press on the handset to connect
to the base. Press on the handset
or on the base again to return to
standby.
Using the page feature
status
memory page/int'com redial/p
flash
•
up/int'com
hold conf int'com
updn
flash
deletecall id
Basics
(continued)
page/int'com
Paging
•
up/int'com
As you begin to move too far from the base, you first hear a clicking sound. As you
travel further, the noise increases. If you travel out-of-range, your call terminates.
Traveling out-of-range
page/int'com
If you encounter interference while using your
phone, you can manually change the channel
for clearer operation. This function works only
when the phone is use.
The button on the handset allows you
to choose between 40 different channels.
During the course of a conversation, if you hear
static or noise which marks it difficult to hear, press . The following screen
apears and the phone changes to a different channel.
Selecting a different channel
chan redial/psel/vol
Scanning
chan
chan
Adjusting the volume controls
Handset ringer volume
When the phone is in standby mode, press the
key on the handset to set the handset
ringer volume.
Handset earpiece volume
During the conversation mode, press .
Each time is pressed, the earpiece
volume selection changes.
chan redial/psel/vol
sel/vol
Ringer High Ringer Low
sel/vol
Normal
Medium
High
Loud
sel/vol
sel/vol
sel/vol
sel/vol
sel/vol
sel/vol
EXI 7926 H1 99.8.23 11:32 AM Page 20