Filter
Top Products
11
Charge the battery pack for 12-15 hours before you plug the
phone into the phone line.
1 Remove the battery cover.
2 Connect the battery pack
connector with the correct
polarity (black and red wires),
then insert the battery pack
into the battery compartment.
3 Slide the battery cover forward
until it snaps into place.
4 Place the handset on the base
with the keys and display
facing upward.
This position lets you see the
Caller ID messages on the
display.
Make sure that the
“status”
LED of the base unit is lit, and
charging begins. Charge the
battery for 12-15 hours.
You can place the handset
either side up for charging the
battery.
Use only Uniden Battery
BT-905.
Replacement batteries are
also available through the
Uniden Parts Department.
(See page 5)
EXAI985HS 10/10/00 10:11 Page 11