Filter
Top Products
7
Step 2
(continued)
Connect the base unit
If you want to install the base unit on the wall, see page 45.
1 Connect the telephone line cord to the
TEL LINE jack and to a telephone
outlet.
Note Until the handset battery is
fully charged, you can only
answer incoming calls at the
base unit.
2 Connect the AC adapter to the
DC IN 9V jack and to a standard
120VAC wall outlet.
3 Set the base unit on a desk or tabletop
and place the handset on the base
unit.
Then raise the antenna to a vertical
position.
To AC outlet
To telephone outlet
To TEL LINE
To DC IN 9V
AC adapter
(supplied)
Telephone line cord
(supplied)
1
2
Route the cord.
3
Note
Place the power cord so it does not create a trip hazard, or where it could become
chafed and create a fire or electrical hazard.
EXAI 7980 6th HEN 99.8.24 4:52 PM Page 7