Filter
Top Products
32
Caller ID
(continued)
Storing Caller ID messages in Memory
Messages shown in the Caller ID list can be stored for memory dialing.
Using the incoming call information (i.e., Caller ID list), the phone number of the party
on the Caller ID list can be stored in memory dialing.
1 Press .
2 Display the phone number to be
stored from the Caller ID list. (See
page 28.)
3 Press .
4 Press or to select the
memory location where you wish to
store the name and number from
caller ID.
Press the dial buttons ( to )
and select the number (01 to 20).
5 Press .
A beep tone will sound. The number
is stored in memory, and the display
returns to the Caller ID list.
5/17 12:30PM 03
UNIDEN CORP
817-858-3300
Select Location
1 UNIDEN CORP
2 JONE DOE
mem
5/17 12:30PM 03
UNIDEN CORP
817-858-3300
select
•
up
dn
ª
0
9
Notes
• If a message has already been stored in the select-
ed memory numbers location, a verification screen
is displayed.
Press to select “
Yes”.
Press to overwrite. The display returns to the Caller ID list.
• You can not store a Caller ID message if no phone number appears in the message.
• If no key is pressed for more than 20 seconds, an error tone sounds and the
telephone returns to the standby mode.
• If there is an incoming call or page, memory storage is cancelled and the telephone
is set to the incoming call or page. If you get an incoming call, memory storage is
cancelled.
Replace Memory ?
Yes
No
•
up
select
call id
EXAI 7980 6th HEN 99.8.24 4:53 PM Page 32