Filter
Top Products
▼
One-touch priority dialing
Your phone is equipped with three “One-Touch Priority” keys for
instant dialing. You cannot store phone numbers directly into
m1
,
m2
or
m3
. They are only used to dial phone numbers stored into
memory locations 1, 2 and 3. (See “Storing a Phone Number in
Memory,” page 13.)
To instantly dial phone
numbers stored in memory
locations 1, 2 or 3, simply press
m1
,
m2
or
m3
. (There is no
need to press talk; the phone
will automatically dial.)
If you press m1, m2 or m3, and no phone number was stored in
memory locations 1, 2, or 3, the phone will beep rapidly but will
not dial.
CHAIN DIALING
On certain occasions after dialing a number, you may be requested to
enter an access code, such as your account number. You can enter this
number into a memory location for later use by doing the following.
1) Store the access code into one of the memory locations (0-9) or
memory keys
m1
,
m2
,or
m3
following the steps above.
2) Dial the party or service main number.
3) When you need to enter the special number, press
mem
followed by
the memory location (0-9) or memory keys
m1
,
m2
,or
m3
ERASING A STORED NUMBER FROM MEMORY
1) Remove the handset from the base unit.
2) Press the
mem
button twice.
3) Press the memory location (0-9). A tone indicates that the stored number
is erased from memory.
14
tone
redial pause volumechan
m1 m2 m3
78
0
#
9
pqrs
tuv
oper
wxyz
m1,m2,
m3
NOTE
You cannot erase the phone numbers from memory
locations 1-3 by pressing the
m1
-
m3
keys. You must
use the keypad (1-3) for these locations.
NOTE
An error sounds and the
erase procedure will be
canceled if more than 20
seconds elapse between
each keystroke.
H:...reprint 8-13-99EXA7950.vp
Tue Aug 17 15:31:45 1999
Color profile: Disabled
Composite Default screen