Filter
Top Products
Additional Information
Additional Information
continued
49
IntercomAnswering machineOperating from an
outside phone
Power source/battery
Remedy
• The handset may be engaged in conversation.
• The battery may be weak. Charge the battery for 15-20
hours (page 11).
• Move the handset closer to the base phone.
• Place the base phone away from noise sources
(page 8).
• The remaining recording time is less than 30 seconds
or 59 messages were recorded. The answering machine
becomes “Memory full” status and does not record
messages. Erase messages (page 40).
• The message is less than two seconds. The answering
machine does not record messages less than two
seconds in length.
• Adjust the speaker volume (page 40).
• The caller’s message is too long.
• The caller’s voice is too low. The phone disconnects
the line when it detects seven seconds of silence.
• There was a power interruption. Reset the time
(page 32).
• Make sure you call from a touch-tone phone.
• Make sure the remote ID code (security code) is
correct.
• Make sure you entered the remote ID code (security
code) within two seconds after you’ve entered .
• You entered wrong remote ID codes (security codes)
three times.
• Wipe the charge terminals of the base phone and the
handset with a soft cloth for better contact of the
charge terminals.
• Make sure the handset is placed on the base phone
properly.
• The battery pack was charged for 15-20 hours (due to
power failure, etc.).
• The usage life of the battery has expired and needs
replacement.
Symptom
The handset does not ring
when calling from the base
phone.
Message is not recorded.
No sound from the speaker of
the base phone.
The caller’s message is
interrupted.
The clock is incorrect.
The phone does not accept
your remote ID code (security
code).
The line is disconnected when
you call your phone from a
touch-tone phone.
The CHARGE LED does not
light up when you place the
handset to charge.
The battery duration is short.
EXA2955-9/21 9/21/01 4:45 PM Page 49