Filter
Top Products
Basics
Basics
19
SPEAKER
LED
IN USE
LED
SPEAKER
FLASH
VOL
HOLD
*
TONE
Receiving calls
1 When you hear the phone ring;
• Press
(or any key except ).
or
• Pick up the handset from the
base phone when the handset
is placed on the base phone.
The TALK/BATT LOW LED on
the handset and the IN USE
LED on the base phone light up.
2 When you’re done talking, press
or replace the handset on
the base phone.
The TALK/BATT LOW LED on
the handset and the IN USE
LED on the base phone go off.
OFF
OFF
TALK
Additional tasks
To Do this
Put a call on hold Press .
The TALK/BATT LOW LED flashes slowly.
Press to resume the conversation.
Select a better channel Press .
Adjust the handset volume Set the VOL switch to H (high), M (middle) or L (low).
Switch to tone dialing Press while using the telephone after you’re connected.
temporarily The line remains in tone dialing until disconnected.
Switch to another call Press to access the flash function.
(“call waiting” service*) Press again to return to the first caller.
Turn on/off the ringer See “Setting the ringer type” on page 23.
of the handset
* You need to subscribe to the service from your telephone company.
FLASH
FLASH
*
TONE
CHANNEL
TALK
HOLD
Receiving calls through the speakerphone
When the phone rings, press
on the base phone.
The SPEAKER LED and the
IN USE LED light up.
“- -” appears on the display.
To adjust the speaker volume,
press or .
When you are done talking, press
again.
To obtain the best speakerphone
performance, see page 18.
To adjust the ringer volume, see page 24.
SPEAKER
VOL
VOL
SPEAKER
TALK/BATT
LOW LED
VOL
switch
*
TONE
HOLD
FLASH
CHANNEL
EXA2955-9/21 9/21/01 4:45 PM Page 19