Filter
Top Products
16
Basics
Basics
Making calls
Additional tasks
To Do this
Put a call on hold Press .
The TALK/BATT LOW LED flashes slowly.
Press to resume the conversation.
Select a better channel Press .
Adjust the handset Set the VOL switch to H (high), M (middle) or L
Volume (low).
Switch to tone dialing Press while using the telephone after
Temporarily you’re connected.
The line remains in tone dialing until disconnected.
Switch to another call Press to access the flash function.
(“call waiting” service*) Press again to return to the first caller.
* You need to subscribe to the service from your telephone company.
Notes
• Before dialing, make sure you can hear the dial tone, otherwise you cannot
dial correctly.
• When the TALK/BATT LOW LED repeats a set of two flashes, the base
phone is in use.
• When you set the handset volume to H (high), the volume will be raised
considerably. Under normal circumstances, set the volume to M (middle).
FLASH
FLASH
*
TONE
CHANNEL
TALK
HOLD
1 Pick up the handset from the base
phone.
2 Press .
The TALK/BATT LOW LED on the
handset and the IN USE LED on the
base phone light up.
Then you’ll hear a dial tone. If you
hear error beeps, move closer to the
base phone.
3 Dial the phone number.
4 When you’re done talking, press
or replace the handset on the
base phone.
The TALK/BATT LOW LED on the
handset and the IN USE LED on the
base phone go off.
OFF
TALK
TALK/BATT
LOW LED
VOL
switch
REDIAL/P
*
TONE
HOLD
FLASH
CHANNEL
EXA2955-9/21 9/21/01 4:45 PM Page 16