Filter
Top Products
Basics
Basics
continued
17
SPEAKER
LED
IN USE
LED
SPEAKER
FLASH
REDIAL/P
VOL
HOLD
*
TONE
If the handset battery becomes weak during a call
You hear a beep every three seconds and the TALK/BATT LOW LED on
the handset flashes.
The call will disconnect soon. Replace the handset on the base phone to
charge.
For optimum performance, charge the battery for 15-20 hours.
Note that during the first 10 - 15 minutes of charging, the phone will be
inactive, i.e., unable to make or receive a call.
After this initial 10 - 15 minutes, you may be able to use the phone, but
the battery duration will be very short; thus it is recommended that you
fully charge the battery before the next usage.
Making calls through the speakerphone
Press on the base phone.
The SPEAKER LED and the
IN USE LED light up.
“- -” appears on the display.
Dial the phone number.
When you are done talking, press
again.
SPEAKER
SPEAKER
Additional tasks
To Do this
Put a call on hold Press .
The IN USE LED flashes slowly.
Press to resume the conversation.
Adjust the speaker volume Press or .
Switch to tone dialing Press while using the telephone after
temporarily you’re connected.
The line remains in tone dialing until disconnected.
Switch to another call Press to access the flash function.
(“call waiting” service*) Press again to return to he first caller.
* You need to subscribe to the service from your telephone company.
FLASH
FLASH
*
TONE
VOL
VOL
SPEAKER
HOLD
EXA2955-9/21 9/21/01 4:45 PM Page 17