Toshiba DKT2404-DECT Cordless Telephone User Manual


 
Installation
Step 6: Wall Installation (Optional)
16 Strata CIX DKT2404-DECT User Guide 04/09
Direct Wall Mounting
If you do not have a standard wall plate, you can mount your telephone directly on a
wall. Before mounting your telephone, consider the following:
Select a location away from electrical cables, pipes, or other items behind the
mounting location that could cause a hazard when inserting screws into the wall.
Make sure the wall material is capable of supporting the weight of the base unit.
Use #10 screws with anchoring devices suitable for the wall.
ä To wall mount the base unit
1. Insert two mounting screws 3-15/16 inches apart. Allow about
3/16 of an inch between the wall and screw heads for mounting
the telephone (shown right).
2. Plug and secure the AC adapter cord by following Steps 2 and
3 of the “Standard Wall Plate Mounting” on page 15.
3. Plug one end of the telephone line cord into the LINE jack on
the base unit. Optionally, plug one end of a Strata DKT
telephone into the PHONE jack. Then place the telephone
cord(s) inside the molded channel(s) on the bottom of the wall
mount stand.
4. Place the base unit on the posts of the wall screws
and push down until it’s firmly seated.
5. Plug the other end of the telephone cord into a
telephone wall jack.
6. Plug the AC adapter into a standard 120VAC wall
outlet by following Step 7 of the Standard Wall Plate
Mounting.