Toshiba DKT2104-CT Cordless Telephone User Manual


 
Handset Operation
Transferring Calls
Strata DKT2104-CT Cordless Digital Telephone 5/00 35
Transfer Calls to the DKT
1. Press +2/' on the cordless handset.
2. Pick up the DKT telephone and press the flashing Line LED.
Using Camp-on
1. Press&1)751. You hear dial tone and the Line or [DN] LED flashes
at the conference rate.
2. Enter the destination
[DN], Hunt Group
number, or ACD
group [DN].
You hear a single tone.
Note If the call was made with Tone Signaling
instead of Voice First Signaling, you hear
ringing tone.
3. When the [DN]
answers, announce
the call.
If the called station does not answer, you receive a
recall ring (when your station or
[DN] is idle). The
ring is set by system programming.
4. Press
WDON The Line LED changes to steady when the called
station connects with the transferred call.
...or
/LQH, [DN] +
 to reconnect to
the transferred line
before the call is
answered or busy
tone is received.
The Line LED changes to steady red when the called
station connects with the transferred call. After you
hang up, the Line LED begins to flash at the on-hold
rate or if you transferred the call from a [DN], the
[DN] LED goes out. The CO Line or [DN] camps onto
the called station and the called station receives a
warning tone.
You receive a recall ring when your station or [DN]
is
idle and camp-on is cancelled when the called station
user fails to answer within a predetermined time.
Repeat the procedure if necessary.