Filter
Top Products
58
Getting Started
Installing additional memory (optional)
5.375 x 8.375 ver 2.3
Before you install or remove a memory module, turn off the
computer using the Start menu. If you install or remove a
memory module while the computer is in Standby or
Hibernation mode, data will be lost.
A memory module must be installed in slot A. do not try
to operate the computer with a memory module in slot B
only.
If you install a memory module that is incompatible with the
computer, a beep will sound when you turn on the computer. If
the module is installed in slot A, thee will be a long beep
followed by a short beep. If the module is in slot B, there will
be a long beep followed by two short beeps. In this case, turn
off the computer and remove the incompatible module.
If you use the computer for a long time, the memory modules
become hot. If this happens, let the memory modules cool to
room temperature before you replace them.
You need a standard Phillips no.1 screwdriver for this
procedure.
To avoid damaging the computer’s screws, use a standard
Phillips no. 1 screwdriver that is in good condition.
If the computer is on, begin at step 1; otherwise, skip to step
3.
1 If the computer is on, click Start, Turn off computer.
The Turn off computer window appears.
2 Click Turn Off.
The operating system turns off the computer.