Filter
Top Products
6 Topcom Butler 6040
Topcom Butler 6040
1 Getting started
1.1 Installing the base
For installation, do the following:
• Plug one end of the adaptor into the outlet and the other end into the adapter jack on the
bottom of the telephone.
• Connect one end of the telephone cord with the wall phone jack and the other end to the
bottom of the telephone.
• Put the telephone-and AC power line cord in the base quides as shown on the picture
below:
1.2 Installing the handset
• Open the battery compartment (see below).
• Insert the battery pack with copper pins below and text on battery visible as on picture
below.
• Close the battery compartment.
• Leave the handset on the base unit for 20 hours. The Line/Charge indicator (LED)
on the base unit will light up.
Before you use the telephone for the first time, you must first make sure the battery is
charged for 20 hours. If you do not do this, the telephone will not work optimally.
Telephone cord
Power cable
TEL
Battery pack
Back view of hand-set