Filter
Top Products
Remote Control Console 29
7.8.5 Dual Function Tone mode Screen
The Dual Function Tone screen is used when operating the C-2002 console with a DSP223 in the 99 Frequency
decode mode.
PROG1 – Toggles between Enable/Disabled.
PROG3 – Returns to Function tone screen.
PROG4 - Returns to the Opening menu screen.
7.9 Supervisor Enable
The supervisor function works in a manner similar to crossmute. It allows a single console to take control of all
selected lines by disabling transmit on all other attached consoles. See section 4.2.2 for information on the wiring
required to support this function. This function should only be enabled on consoles on which a supervisory function
is appropriate.
PROG2 - Disables Supervisory Capability.
PROG3 - Enables Supervisory Capability.
PROG4 - Return to top level menus.
7.10 Alert Programming
The following appears if the ALERT button is pressed while the Opening Menu Screen is showing. This screen
allows the technician to change the cadence of the alert tones. PROG1 selects between the two alert options. Alert
1 dictates which tone cadence will go out with the ALERT button. Alert 2 dictates which cadence will go out when
the ALT button plus ALRT button is configured as a second alert tone.
The PROG2 button scrolls through the available cadences
PROG1 - Selects between Alert 1 and Alert 2.
PROG2 – Selects Hi-Lo Warble or Steady Tone.
PROG3 - Allows editing of the level and frequency for the constant alert tone.
PROG4 - return to the Opening Menu Screen.
Cadence 1 is a steady programmable frequency.
Cadence 2 is a Hi-Lo Warble sound.
7.10.1 Cadence Level Selection
PROG1 - resets the level to the default of 0dBm.
PROG2 - decrements the level by 1 dBm.
PROG3 - increments the level by 1 dBm.
PROG4 - return to the Alert setup menu.
7.10.2 Cadence Frequency Selection
PROG1 - resets the frequency to the default value of 1000Hz.
PROG2 - decrements the frequency by 1Hz (min freq of 0Hz).
PROG3 - increments the frequency by 1Hz (max freq of 3500Hz).
PROG4 - return to Alert Tone setup screen.
DTMF keypad - may be used to program the frequency.
Dual Tone: DISABLED
T
g
l next back
PROG1 PROG2
PROG3
PROG4
Super: Enabled
p
rev next back
PROG1 PROG2 PROG3 PROG4
A
lert 1:1000Hz
A
1/2 Cad edit back
PROG1 PROG2 PROG3 PROG4
A
lert 1:1000Hz
Level Fre
q
back
PROG1 PROG2 PROG3 PROG4
Cad Lvl = 0dB
0dB dwn u
p
back
PROG1 PROG2
PROG3
PROG4
Cad Freq = 2050
1000H dwn u
p
back
PROG1 PROG2 PROG3 PROG4