Filter
Top Products
Remote Control Console 13
7 Setup Mode
7.1 Tech Mode
The tech mode allows a technician to program the internal settings of the C-2002 console. The tech mode is entered
by pressing
MUTE-F6-* simultaneously. The technician will be required to enter a PIN number to allow entry.
See the section 7.4.4.1 on setting up the PIN number. The Opening Menu is displayed when tech mode is entered.
In addition to the information on the display you will visual see the MON, SEL 1-2, MUTE 1-2, F1-F8, SUP and
the ALERT buttons also flash indicating you are in the tech mode of operation. These buttons also provide setup
options when pressed, refer to sections 7.6 and up for additional information.
7.1.1 Erasing all settings
All of the settings in the console can be reset to factory defaults by
pressing and holding both “IC” and “*” and then applying power.
The screen displayed asks if the user wants to restore defaults or not.
PROG1 - Answer, YES and you will clear all settings to the factory defaults.
PROG3 - Answer, NO and you will enter the user mode.
7.1.2 Resetting the PIN Number
In the event the PIN number is either forgotten or not known, the test jumper J15 on the main board inside the unit
can be used to enter a self test mode and reset the PIN. With the power removed from the unit, move J15 to the “B”
position on the board. Power up the board. The PIN number is cleared allowing immediate entry into the tech
mode. Power down the board and move the J15 back to the “A” position. Close the case and resume normal
operations with the C-2002.
Restore Defaults?
YES NO
PROG1 PROG2 PROG3 PROG4