Filter
Top Products
28 Vega’s C-2002
7.7.2 Incoming Select Call DTMF String Setup
The C-2002 has the capability of recognizing 3 different incoming DTMF strings on any line, monitored or not.
When this programmable string is decoded, the unit will Un-mute the line for a programmable period of time (see
Select Call Timer Duration Setup) to allow the remote user the opportunity to make a short transmission which the
console operator can monitor. After the programmable period of unselect time has expired, the Unselect LED (Red
led) for the line on which the DTMF string was decoded begins to flash and continues to flash until a PTT operation
is completed on that line. This blinking light serves as a reminder to the console operator that a call was received
and needs a response. Editing the incoming DTMF sequence is completed from the screen shown. The digits are
entered with the DTMF keypad and the programmable keys; use the “D” key as save/enter function.
PROG1 – Enter the Edit Screen.
PROG2 – Selects DTMF decode screen.
PROG3 - Go to the sixth DTMF screen.
PROG4 - Return to Tone Settings Screen.
7.8 Function Tone Parameter Screen
7.8.1 Function Tone Enabled/Disable
Pressing F1-F8 from the main setup screen enters the function tone parameter screen. The examples below appear
if F8 is pressed.
PROG1 - Toggle between the Enabled and Disabled.
PROG2 - Go to the Frequency programming screen.
PROG3 - Go to the Dual Frequency programming screen.
PROG4 - return to Opening Menu Screen.
7.8.2 Function Tone Setup
The top line of the display shows selected function number, the next item is the actual frequency of the function
tone, followed by the duration of the tone in milliseconds.
PROG2 - Allows editing of the Frequency of the Function Tone.
PROG3 - Allows editing of the Duration of the Function Tone.
PROG4 - Returns to the previous menu.
7.8.3 Frequency Programming Screen
The frequency programming screen will allow the user to change the value of the displayed function tone
PROG1 - Sets the value back to the default of 1950 Hz.
PROG2 - Decreases the frequency by 1 Hz.
PROG3 - Increases the frequency by 1 Hz.
PROG4 - returns to the function tone setup menu.
7.8.4 Duration Display Screen
The Duration Display Screen shows the duration of the select function tone and displays it on the top line of the
display for editing.
PROG1 - Sets the value back to the default of 40ms.
PROG2 - Decreases the frequency by 1 ms.
PROG3 - Increases the frequency by 1 ms.
PROG4 - returns to the function tone setup menu.
DTMF RX1: 1234
Edit Num next back
PROG1 PROG2
PROG3
PROG4
F8 Enabled
T
g
l Tone next back
PROG1 PROG2
PROG3
PROG4
F8: F=1250 D=40
Fre
q
Dur back
PROG1 PROG2
PROG3
PROG4
F8 Freq = 1950
1950 dwn u
p
back
PROG1 PROG2
PROG3 PROG4
F8 Dur = 40
40 dwn u
p
back
PROG1 PROG2
PROG3
PROG4