Filter
Top Products
16 Vega’s C-2002
7.3.1 Menu 1 - Line Level Settings
This screen is displayed after a line has been selected from the Level Menu Screen. The selected line number is
shown on the display and the select LED for that line continues to blink. In this example Line 1 has been selected.
PROG1 - Go to RX Input Level Screen.
PROG2 - Go to LAM level setup.
PROG3 - Go to Line Levels Screen.
PROG4 - Return to Level Menu Screen.
7.3.1.1 RX Input Level Screen
The RX input levels serve as a master level adjustment allowing small adjustments in gain. This is a per line
adjustment. Typically these are left at 0 dB.
PROG1 - Resets level setting to default of -60dB.
PROG2 - Increments the level setting by 1 dBm (max of 0dB).
PROG3 - Decrements the level setting by 1 dBm (min of -60dB).
PROG4 - Return to Other Line Level Screen.
7.3.1.2 LAM Programming Screen
This screen shows the current settings for the Line Activity Monitor for the line number shown. The -U or -S after
the channel number denotes whether the settings are for Select or Unselect Audio. Pressing PROG1 or PROG2 will
modify the settings for the Select or Unselect characteristics displayed when the button is pressed.
PROG1 - go to LAM Duration After Release screen.
PROG2 - go to LAM Trigger Level Screen.
PROG3 - Toggle Select or Unselect LAM control.
PROG4 - Return to Other Line Level Screen.
7.3.1.2.1 LAM Duration After Release screen
This parameter determines how long the LAM light will flash after the triggering signal disappears.
PROG1 - Resets duration setting to default of 7 seconds.
PROG2 - Increments the time setting by 1 second (maximum of 25sec).
PROG3 - Decrements the time setting by 1 second (minimum of 0sec).
PROG4 - Saves the current duration setting and returns to the LAM
Programming Screen.
7.3.1.2.2 LAM Trigger Level Screen
These parameters determine the audio level required to trigger the LAM function.
PROG1 - Adjusts level at which the LAM triggers.
PROG2 - Increments the level setting by 1 dBm (max of 0dBm).
PROG3 - Decrements the level setting by 1 dBm (min of -30dBm).
PROG4 - Saves the current level setting and returns to the LAM
Programming Screen.
7.3.1.3 Mute Button Level Screen
These parameters are used to set the level of Mute on a Per line bases.
PROG1 – Sets level of mute to off (total quite).
PROG3 – Go to Edit level screen.
PROG4 - Return to Level Menu Screen.
Line 1 level adjust
RX LAM back
PROG1 PROG2
PROG3 PROG4
Ln1 Min Rx lvl -60dB
-60dB dwn u
p
back
PROG1 PROG2
PROG3
PROG4
LAM1-S 7sec -10dBm
dur lvl S/U back
PROG1 PROG2
PROG3 PROG4
LAM1-S Duration 7se
7sec dwn u
p
back
PROG1 PROG2
PROG3
PROG4
LAM1-U Level -10dB
-10dB dwn u
p
back
PROG1 PROG2
PROG3
PROG4
M
ute1 Level = -10dB
OFF edit back
PROG1 PROG2
PROG3
PROG4