Filter
Top Products
1 7. Snug the slide block set screw until the brass
plug is slightly pre-loaded against the pivot
pin (see Figure 14).
Figure 14. Slide block set screw adjustment.
18. Replace the attachment body top cover.
19. Loosen the two cap screws on top of the
deadman clamp (see Figure 15), then slide
the clamp onto the rear bedway from the
tailstock end.
20. Thread the arm clevis into the taper
attachment, then position the deadman
clamp so the end of the arm slides into the
arm clamp, as shown in Figure 16.
Note: Do not tighten the arm clamp cap screw or
the arm clevis hex nut at this time.
!
Figure 15. Deadman clamp.
Clamping
Plate
Arm
Clamp
Cap Screws
21. Position the deadman clamp towards the end
of the arm, then tighten the deadman clamp
cap screws to secure the assembly to the
bedway.
22. Loosen the dovetail cap screws at each end of
the taper attachment body (see Figure 17).
23. Turn the taper adjustment knob to bring the
dovetail to zero on both scales.
Figure 17. Taper adjustment knob and controls.
Rear
Angle Scale
Adjustment Knob
Dovetail Cap
Screw (1 of 2)
Figure 16. Deadman clamp and arm.
Arm Clamp
Arm
Clevis
Deadman Clamp
Cap Screws
Mfg. Since 9/11 Model SB1263
-7-
INSTRUCTIONS