Filter
Top Products
4. Loosen both dovetail cap screws (see
Figure 25).
Figure 25. Dovetail cap screw
(1 of 2).
Dovetail Cap
Screw (1 of 2)
Note: Depending on the operation, use either the
rear scale (degrees of taper) or the front scale
(amount of taper per inch of workpiece) in
the next step (see Figure 26).
Taper Angle
Rear Scale Front Scale
Taper Per/Inch
Workpiece
Length
Figure 26. Rear and front scales.
5. Turn the taper adjustment knob to set the
required taper, then re-tighten both dovetail
cap screws.
Disengaging Taper Attachment
1. DISCONNECT LATHE FROM POWER!
2. Loosen both deadman clamp cap screws (see
Figure 27)
Figure 28. Dovetail way cap screw
(1 of 2).
Dovetail Cap
Screw (1 of 2)
Figure 27. Deadman clamp cap screws.
Deadman Clamp
Cap Screws
3. Loosen the dovetail way cap screws at each
end (see Figure 28).
4. Turn the taper adjustment knob until both
scales read zero.
5. Re-tighten both dovetail way cap screws.
Mfg. Since 9/11 Model SB1263
-11-
INSTRUCTIONS