Filter
Top Products
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at
(360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
Inventory
Inventory (Figure 3) Qty
A. Cap Screws M8-1.25 x 45mm ........................4
B. Taper Attachment Assembly ......................... 1
C. Taper Pins 8.7 x 7.7 x 47mm ......................... 2
D. Deadman Clamp Assembly ...........................1
E. Deadman Arm Assembly ...............................1
Figure 3. Model SB1263 inventory.
A
B
C
D
E
Required for Setup
The items listed below are required to
successfully set up and prepare this taper
attachment for operation. The installation
is intended to be permanent and will take
approximately one hour.
For Assembly
• Another person
• Cotton shop rags
• Mineral spirits
• Safety glasses
• Oil can with any general machine oil
• White lithium grease
• Wrench 17mm
• Hex wrenches 3, 4, 5, 6, and 8mm
• Phillips screwdriver #2
• Precision ruler
• Drill bit
19
⁄64"
• Tapered drill bit 8mm
• Spiral pin reamer #6
— Small end diameter: 0.2773"
— Large end diameter: 0.3540"
• Small metal hammer
• Dial indicator w/magnetic base
Mfg. Since 9/11 Model SB1263
-3-
INSTRUCTIONS