Sony SX-M100 Telephone User Manual


 
21
Troubleshooting Guide
Should a problem arise in your system, check the system while referring to the
instructions in the table below. If the system continues to malfunction after
applying the following checks and remedies, contact your nearest Sony dealer.
The system indicates the problem by lighting the microphone indicator and MIC
ON/OFF button of chairmans/delegates units.
Lighting of the
microphone indicator
and MIC ON/OFF button
of the chairmans unit/
delegates unit
Possible cause Remedies
The indicator and button
blink for a few seconds
when the POWER
switch of the control unit
is set to ON.
The chairmans unit/
delegates units for a
conference system, SX-
C100A/D100A/SX-C150/
D150, and those for a
simultaneous
interpretation conference
system, SX-C700A/
D700A/SX-C750/D750,
have been connected.
The SX-C700A/D700A/SX-C750/D750 can be used.
However, same sound is output from channel 1 to channel 6.
The indicator and button
of the chairmans/
delegates units
continue to blink, after
the power switch of the
control unit is set to ON.
The units whose indicator
and button are blinking
cannot be controlled by
the control unit and cannot
be used in this system.
When the indicator and button of units subsequent to the
16th unit of the units connected to one DELEGATES/
CHAIRMANS connector of the control unit blink:
More than 16 units cannot be connected to one
DELEGATES/CHAIRMANS connector in series.
Disconnect the 16th unit and subsequent units.
Even though the number of connected units is less than 16,
the indicators of some of the connected units blink:
The first unit whose indicator and button are blinking may
be defective, or the connecting cable may be broken.
Disconnect the first unit of those whose indicator and
button are blinking. When the indicator and button of the
subsequent units stop blinking and go out, it indicates
that the disconnected unit was defective. Remove it from
the system or replace it with a functioning unit.
When the indicator and button continue to blink even
after removing the first unit, the connecting cable is
probably broken. Replace the connecting cable linking
the first unit whose indicator and button are blinking and
the unit immediately prior to that unit.
Even though the number of connected units is less than 16,
the indicator and button of some of the connected units
blink:
The unit whose indicator and button blink is defective.
Disconnect it from the system or replace it with a
functioning unit.
After the unit has been
operated for a while
after the power is turned
on, the units indicator
and button start blinking
and do not go out, even
after a few seconds.
A communication error
has occurred.
Briefly turn the power off, then back on again.
If the unit subsequently operates normally, communication is
resumed.
If this problem occurs frequently, contact your nearest Sony
dealer.
If the indicator and button continue to blink just after the
power is turned on again, a problem described above may
have occurred. Proceed as described above.
The volume of the
earphone cannot be
adjusted by using the
VOL control.
The earphone may be
disconnected.
Insert the earphone plug into the earphone jack surely.
The indicator and button
blink and the
microphone is disabled
even if the MIC ON/OFF
button is pressed.
The mode is that where
the number of speakers
is limited.
The PRIORITY button is
held down by the
chairman.
Wait until the speaker finishes speaking. Press the MIC
ON/OFF button again.
Wait until the chairman releases the PRIORITY button.