Filter
Top Products
13
SX-T100 Telephone Coupler
SX-T100 Telephone Coupler
1CONTROL UNIT connector
2Power indicator
3POWER ON/OFF switch
4Handset-securing tape
Movable part A
4 Handset-securing tape
After being connected to other party telephone,
place your handset on the telephone coupler and
secure it with the handset-securing tape. Adjust the
movable part A in the above illustration, to fit the
handset being used.
Note
If the handset is not secured firmly,
communication may not be satisfactory.
1 CONTROL UNIT connector (6-pin multi-
connector)
Connect to the TELEPHONE COUPLER
connector of the SX-M100 Control Unit, using the
connecting cord supplied with the SX-T100.
2 Power indicator
This indicator lights when the telephone coupler
power is turned on.
3 POWER ON/OFF switch
Turns the telephone coupler power on or off .
Note
When the POWER ON/OFF switch is set to ON,
howling or noise may arise because the
microphone and the speaker are enabled. When the
telephone coupler is not used, set the POWER ON/
OFF switch to OFF.