Filter
Top Products
Hookups
19
Hookups
Hooking Up the Player
Follow Steps 1 to 4 to hook up and adjust the settings of the player.
Before you start, turn off the power, check that you have all of the supplied accessories, and insert
the batteries into the remote (page 15).
Notes
• Plug cords securely to prevent unwanted noise.
• Refer to the instructions supplied with the components to be connected.
Step 1: Connecting the Video Cords
Connect this player to your TV monitor, projector, or AV amplifier (receiver) using a video cord.
Select one of the patterns A through C, according to the input jack on your TV monitor, projector,
or AV amplifier (receiver).
INPUT
S VIDEO
B
CR
CB
Y
COMPONENT
VIDEO IN
C
AUDIO
INPUT
L
R
A
VIDEO
DIGITAL OUT
WOOFER
L
R
FRONT REAR
CENTER
LINE OUT
R – AUDIO 2 – L VIDEO 2
R – AUDIO 1 – L VIDEO 1
1
2
PCM/DTS/MPEG/
DOLBY DIGITAL
COAXIAL
OPTICAL
S VIDEO
OUT
5.1CH OUTPUT
COMPONENT
VIDEO OUT
Y
C
B
C
R
SACD/DVD player
TV, projector, or AV
amplifier (receiver)
l : Signal flow
Component video
cord (not supplied)
Audio/video cord
(supplied)
S VIDEO cord (not supplied)
(yellow)
(yellow)
TV, projector, or AV
amplifier (receiver)
TV, projector, or AV
amplifier (receiver)
(green)
(blue) (red)
(green)
(blue)
(red)
continued