Filter
Top Products
7
Mounting on a wall
Do not attempt to wall mount the phone before initial 12-hour charging
is complete.
8. Remove the handset from the base and set aside.
9. Turn the base over and unplug the AC adaptor and telephone cords.
Run the cords through the square hole on the wall mount. Plug
them back in to the base (1 and 2, above).
Note: If you use Pulse (rotary) dial service, repeat Step 7 under
“Tone/Pulse setting”.
10. Align the four slots on the bottom of the base with the four hook-
tabs on the bracket.
11. Insert the hook-tabs into the slots and push up until the bracket
snaps securely into place.
12. Slip the mounting holes over the wall plate posts and slide the unit
down firmly into place. (Wall plate not included.)
13. Place the handset in the base.
Note: If desired, gather the extra AC adaptor cord and telephone cord
together, fasten with a wire tie, and store inside the wall mounting
bracket.
Digital Security System
Your cordless phone uses a digital security system to provide protection
against false ringing, unauthorized access and charges to your phone
line. When you place the handset in the base, the phone verifies its
security code. After a power outage or battery replacement, you should
place the handset in the base for about 20 seconds to reset the code.
GETTING STARTED
1
2