Sanyo CLT-J30 Cordless Telephone User Manual


 
28
Dial tone is OK, but cannot dial out
Make sure the TONE/PULSE dialing mode is set to TONE or PULSE
according to your phone service.
Handset does not ring
Make sure the RINGER switch on the handset is turned to ON.
You may have too many extension phones on your line. Try
unplugging some phones.
See solutions for No dial tone.
You experience static, noise, or fading in and out
Change channels.
Is handset out of range? Move closer to the base.
If you hear 3 short beeps when you press TALK/CALL BACK, you
are out of range.
Does the base need to be relocated?
Charge battery.
Make sure base is not plugged into an outlet with another house
hold appliance.
Phone beeps
Place handset in base for a minimum of 20 seconds to reset the
security code. If that does not work, charge battery for 12
continuous hours.
Clean charging contacts on handset and base with a soft cloth or
an eraser.
See solutions for No dial tone.
Replace battery.
Dialing from Memory
Did you program the directory keys correctly?
Did you follow proper dialing sequence?
Make sure the TONE/PULSE dialing mode is set to TONE or PULSE
according to your phone service.
Did you reprogram directory after a power outage or battery
replacement?
TROUBLESHOOTING