Sanyo CLT-J30 Cordless Telephone User Manual


 
23
Battery replacement and handling
When the operating time becomes short even after a battery is recharged,
please replace the battery.
With normal usage, your battery should last about one year.
For a replacement battery, please contact your place of purchase or fill
out and mail the enclosed form.
Caution:
Use only the specified battery type (3.6V, 600mAh).
Do not remove the battery from the handset to charge it.
Never throw the battery into a fire, disassemble it, or heat it.
Do not remove or damage the battery casing.
Remove battery if storing the phone for over 30 days.
Make sure the telephone is off before you replace the battery.
1. Slide off the battery compartment cover.
2. Disconnect the battery plug from the jack in the compartment and
remove the battery pack.
3. Insert the new battery pack and connect the cord into the jack.
Note: Please refer to the pictures on page 6, “Battery setup” for
guide.
4. Put the battery compartment cover back on.
5. Place handset on the base to charge for 12 hours.
Note: If the handset battery is removed for more than 5 minutes, the
directory memory and caller ID memory will be erased.
Charge the handset battery for 12 hours continuous prior to first use.
The initial battery charge is important for best performance.
Caution: To reduce the risk of fire or personal injury, use a 3.6 V,
600mAh battery.
Replacement part number: GES-PC3F03.
CHANGING THE BATTERY