Filter
Top Products
20
You can store up to 10 names (up to 15 characters) and numbers (up to
24 digits) in the directory for quick dialing. If a number exceeds 24
digits, you can program it in parts, and then chain dial the number.
Store a number in the directory
To program a number to memory:
1. Make sure the phone is OFF (not in TALK Mode).
2. Press MEM key to start the Memory Programming Mode. “MEMO
# --” shows on the screen.
3. Select the desired memory location (0 – 9) or use the CID/VOL
or
keys to find an empty memory location.
4. Press the MEM key again. The screen shows “ENTER NAME”
5. Use the digit keys to enter the name. The cursor advances 1 space
after each key press. Within 1 second, you can press the same key
again to select another character. If you make a mistake, press CH/DEL
to delete previous characters one by one.
DIRECTORY
Key Press 1 2 3 456789
1
st
– 5
th
press A D G J M P T W
2
nd
– 6
th
press – BEHKNQUX
3
rd
– 7
th
press * C F I L O R V Y
4
th
– 8
th
press ! ( ) $ ’ ; S ? Z
6. Press MEM again to save the name. “ENTER TEL NUMBR” shows
on screen.
7. Use the digit keys to enter the desired telephone number. If you
make a mistake, press CH/DEL to delete previous digits one by one,
then enter the correct digits. If you wish to add a pause, press
PAUSE two times at the desired location. Be sure to press it twice,
or you will enter a # (number sign) and not a pause. Each pause
counts as 1 digit in the dialing sequence. Or you can store redial
number in the directory by pressing REDIAL (Note: If the redial
number is longer than 24 digits, it can not be stored into the
memory.).
8. Press MEM again to save the number. “ANIMATION
0” shows on
screen. “0” means the animation feature is disabled.