Filter
Top Products
8
Placing the Phone on a
Desk Top
Follow these steps when you place the
base on a desk, shelf, or table.
1. Remove the stand from the bottom
of the phone by pressing and hold-
ing in both spring tabs, then gently
pulling the wide end of the stand
and lifting it off.
2. Plug one end of the supplied modu-
lar cord into the
L1 & 2
jack on the
bottom of the phone, then route the
cord through the TELEPHONE
LINE(S) slot.
3. Insert the supplied AC adapter’s
barrel plug into the POWER jack on
the bottom of the telephone, then
route the AC power cord through the
AC ADAPTER CORD slot.
Do not plug the adapter into the AC
outlet at this time
.
Caution:
The supplied AC adapter
supplies 12V DC, delivers at least
300 mA, and has a plug that proper-
ly fits the telephone’s POWER
jack.
Using an adapter that does not meet
these specifications might damage
the telephone or the adapter.
4. Insert the tabs on the narrow end of
the supplied stand into the upper
slots near the center of the phone,
push the wide end of the stand until
it clicks into place, then place the
Speakerphone on the desk.
43-463.fm Page 8 Friday, August 13, 1999 9:06 AM