Radio Shack ET-908 Cordless Telephone User Manual


 
15
OPERATION
Important
: If you move the handset
outside the base’s range, the handset
will not operate properly and a call in
progress might be disconnected (see
“Troubleshooting” on Page 21).
MAKING/ANSWERING
CALLS
To make a call, simply lift the handset
and press
TALK
. When you hear the
dial tone, dial the desired phone num-
ber or memory number (see “Using
Memory Dialing” on Page 18).
To answer a call if the handset is on
the base, simply lift the handset and
begin your conversation.
To answer a call if the handset is not
on the base, press any key on the
handset except
OFF
before speaking.
Notes
:
Both the IN USE indicator on the
base and the TALK indicator on
the handset flash when you
receive a call, and light steadily
while the handset is in use.
If the handset’s ringer is turned on
and you press
OFF
while the
handset is ringing, the handset’s
ringer turns off for that call only,
then it automatically turns on
about 5 seconds after the call
ends.
To turn the handset’s volume up
or down during a call, press or
on the side of the handset.
To end a call, place the handset on the
base or press
OFF
. The IN USE indica-
tor on the base and the TALK indicator
on the handset turn off.
TALK CH OFF
PRIVACY / LOW BATT
123
ABC
DEF
TALK
MEMORY DIALING
CHARGE
IN USE
PAGE
POWER
PAGE
TALK CH OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL
PROG
43-1083.fm Page 15 Tuesday, August 17, 1999 2:17 PM