Filter
Top Products
Operation
9
CHOOSING THE DIALING MODE
Most phone systems use tone dialing which sends
standard tones through the phone lines. However,
some phone systems still use pulse dialing such as
in rural areas. The default setting is tone dialing.
Depending on your dialing system, set the mode as
follows: Ô
1. Press and hold the
REMOTE until you hear a
confirmation tone.
2. To set the dial mode for pulse dialing, press #.
Or to set the dial mode for tone dialing, press
/TONE.
You hear a confirmation tone to indicate the
setting is complete.
OPERATION
MAKING AND RECEIVING CALLS
Even when you turn off the base’s ringer, you can
still make or receive calls using this phone.
Telephones on the same line and the handset still
ring when there is an incoming call.
Action Handset On Base Handset Off Base
To
receive
a call
Pick up the handset
(Auto Talk).
Press TALK/FLASH,
any number, /TONE
or #.
To
make a
call
1)Pick up the
handset.
2)Press TALK/
FLASH.
The TALK/BATT
LOW LED flashes
and turns on.
3)Listen for the dial
tone.
4)Dial the number.
1)Press TALK/
FLASH.
The TALK/BATT
LOW LED flashes
and turns on.
2)Listen for the dial
tone.
3)Dial the number.
Ô NOTES Ô
• Make sure your battery
pack is fully charged
before choosing the
dialing mode.
• If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave the
setting as is, otherwise
set for pulse dialing.
• If your phone system
requires pulse dialing
and you need to send
the standard tones for
certain situations during
a call, you may “switch-
over” to tone dialing
(refer to “Tone Dialing
Switch-over” on page
11).
43-3856.FM Page 9 Saturday, February 28, 2004 6:45 PM