Filter
Top Products
The Integrated Answering Device
17
Setting the Time
The clock on the answering system starts when
power is supplied to the base. Follow these steps to
set the clock to the correct time. Ô
1. Press
MENU/CLOCK.
The system announces “Time”, the current time
and the guidance for setting the time.
2. Press
/VOL/SEL or /VOL/SEL until the
correct day is announced. The numbers [ ]
through [ ] are displayed on the base.
3. Press SET to select the day.
4. Press
/VOL/SEL or /VOL/SEL until you hear
the correct hour setting. The numbers [ ]
through [ ] are displayed on the base.
5. Press SET to select the hour.
6. Press
/VOL/SEL or /VOL/SEL until you hear
the correct minute setting. The numbers [ ]
through [ ] are displayed on the base.
7. Press SET to select the minute.
8. Press
/VOL/SEL or /VOL/SEL until you hear
the correct AM or PM setting. The message
counter displays [ ] or [ ].
9. Press SET to select the AM/PM setting.
You hear a confirmation tone. Then the
announcement “Time” and the day and time are
announced for your review. After a few seconds, the
system announces “To set security code, press
menu again”.
Ô NOTES Ô
• Normally the idle time for
the menu mode is ten
seconds before the
system returns to
standby. However for
setting the time, the idle
time is extended to two
minutes.
• Press and hold
/VOL/
SEL
or /VOL/SEL to
quickly scroll through the
numbers on the display.
43-3856.FM Page 17 Saturday, February 28, 2004 6:45 PM