Filter
Top Products
Operation
11
TONE DIALING SWITCH-OVER
Some telephone companies use equipment that
requires pulse dialing (sometimes referred to as
rotary dialing). If you need to enter tone dialing
digits, you can switch-over to tone dialing during the
call. For example, entering your bank account
number after you have called your bank. Ô
Initially make your call with the pulse dialing mode.
Once your call connects, press
/TONE. Enter the
desired number. These digits will be sent as tone
dialing. Once the call ends, the tone mode is
canceled and pulse dialing mode resumes.
TRAVELING OUT-OF-RANGE
During a call, as you begin to move your handset
too far from your base unit, your call will terminate
within one minute.
SELECTING A DIFFERENT CHANNEL
If you encounter interference while using your
phone, you can manually change the phone’s
channel for clear operation. This function works
only when the phone is in use.
Press CH. The TALK/BATT LOW LED flashes,
indicating the phone is changing to another
channel.
PAGE
To locate the handset (while it’s off the base), press
PAGE on the base. The handset beeps for 60
seconds.
Paging is cancelled when you press any key on the
handset, you press
PAGE on the base, or the
handset is placed on the base. Ô
Ô NOTES Ô
Tone Dialing Switch-over
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number can
be stored in a memory
location. This is referred
to as Chain Dialing. (See
“Chain Dialing” on
page 13.)
Page
Paging is also canceled
when the phone receives
an incoming call.
43-3856.FM Page 11 Saturday, February 28, 2004 6:45 PM