Radio Shack 43-3856 Cordless Telephone User Manual


 
The Integrated Answering Device
29
3. Press
0. And then enter your PIN code. The
answering system announces the current time
and the number of messages stored in
memory. You hear “To play incoming message,
press
02. For help, press 10”.
4. Press
0. And then 6 to turn the answering
system On. You hear the outgoing message
and a confirmation tone.
5. Hang up the phone and subsequent calls will
be answered by the system.
Remote access with the handset
You can operate your answering system from
another room using a handset. Ô
1. With the phone in standby mode, press
REMOTE on the handset. The TALK/BATT LOW
LED flashes and turns on. The answering
system announces the current time and the
number of messages stored in the memory.
2. You hear “To play incoming message, press 2.
For help, press 0.” You hear intermittent beeps.
3. Enter a command within 15 seconds. You may
select a command from the following chart:
Command Function
/1 Repeat a Message
/2 Play Incoming Messages
/3 Skip a Message
/4 Delete a Message
/5 Stop Operation
6 Answering System On
9 Answering System Off
0 Voice Prompts
Ô NOTES Ô
If you press END before
the base is connected,
the phone will return to
standby.
If the base is not
connected within five
seconds, you hear
beeps and the phone will
return to standby.
The base's keypad is
disabled during remote
operation.
If you receive a call, the
remote operation is
canceled.
During the remote
operation [--] appears
on the base.
If you have new
messages and old
messages, only the new
messages will be
played. After you have
reviewed your new
messages, you can play
your old messages by
pressing /2 again.
43-3856.FM Page 29 Saturday, February 28, 2004 6:45 PM