Filter
Top Products
Chapter 1- Hardware Description
1-20
For more information about specific card connections, see:
• "RTM-IP 4000” on page 1-34
• "RTM ISDN” on page 1-36
• "RTM LAN” on page 1-35
First-time Power-up
1 For first entry installation, you must insert the USB key containing the
modified IP addresses in USB port on the RMX’s back panel.
2 AC System - Turn ON the power by pressing on the power switch
located on the rear panel of the RMX 4000.
DC System - Turn ON the Main that supplies power to the RMX and
then turn ON the circuit breaker on the each of DC power rail
modules.
The parameters in the lan.cfg file are uploaded from the USB key to
the RMX’s memory and applied during the power-up sequence.
System power-up sequence may take up to five minutes.
During the First-time Power-up the red ERR LED on the RMX’s front
panel remains ON until both the Management and IP Network Services
have been defined.
When the RMX's configuration is completed (including the
Management and IP Network Services), and if there are no System
Errors, the green RDY LED on the CNTL module (on the RMX’s front
panel) turns ON.
3 Remove the USB key.
For more information about modifying the lan.cfg file on the USB key, and using
the USB key, see the RMX 2000/4000 Getting Started Guide, "Procedure 1:
First-time Power-up” on page 2-14