Filter
Top Products
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-K.doc Page 33
Screen 2
• Jitter = average error or “wobble” in received packet timing, in microseconds
• LastRate = Last successful transmit data rate
• GatewyType = Gateway type
J i t t e
r n n
n
n n
L a s t R
a
t e
n n
n
n n
G a t e
w
y
T
y
p
e
m
n
e
m
o
Where:
• mnemo – A mnemonic that indicates what type of gateway is being used
• SawA2 – All handsets are rate limited to 2Mb because a 500 series NetLink
Wireless Telephone is on the network.
• 11Mb – Gateway with SVP Server and no 500 series NetLink Wireless
Telephones. This system can run at the full 11Mb speed.
Screen 3
Screen 3 contains a list of the APs that are heard and the following parameters from
each AP:
• Indicator as to whether this is the current AP or an index into the list of other
APs heard
• Last 2 octets of the MAC address of the AP
• Channel number
• Signal strength
• Either the 802.11 Association ID from the current AP or a mnemonic for the
reason code indicating why the handset didn’t hand off to this other AP.
C : m m
m
m
c
h
-
s
s
a i d
1 : m m
m
m
c
h
-
s
s
m
n
e
m
2 : m m
m
m
c
h
-
s
s
m
n
e
m
3 : m m
m
m
c
h
-
s
s
m
n
e
m
Where:
• C – Indicates the AP that the handset is currently using
• n – Indicates an index into the list of other APs, where n is equal to 1, 2, or 3
• mmmm – This hexadecimal number is the last 2 octets of this AP’s MAC
address
• ch – Channel number the AP is configured on
• -ss – Signal strength for the AP in dBm
• aid – The Association ID for the currently associated AP
• mnem – A mnemonic that indicates why the handset didn’t hand off to this
other AP:
Unkn – Reason unknown
Weak – Signal Strength too weak
Rate – One or more basic rates not supported