Filter
Top Products
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
PN: 72-1065-09-K.doc Page 20
WPA-PSK The security features of WPA (Wi-Fi Protected Access) using PSK (pre-
shared key) are available and may be used if supported by the access points in the
facility. Select either Passphrase and enter a passphrase between 8 and 63 characters
in length or Direct Entry and enter the 256-bit key code.
WPA2-PSK The security features of WPA2 using PSK are available and may be used
if supported by the access points in the facility. Select either Passphrase and enter a
passphrase between 8 and 63 characters in length or Direct Entry and enter the 256-
bit key code.
Consult the
Configuration Guide
for the access points installed in your
facility for information on which of the WPA versions are recommended
by SpectraLink engineering. Configure the recommended version on the
AP and select the corresponding option on the Admin menu.
Regulatory Domain
The Regulatory Domain will default to North America on the handset display. FCC
requirements dictate that the menu for changing the domain be available by
password, which in our case is the LINE key. To change the domain, press LINE and
then enter the digits that represent the site’s domain. Note that both digits must be
entered.
01 - North America
02 - Europe (except Spain and France); Japan (channels 1-13)
04 - Spain
05 - France
As of this writing, Spain and France are adopting the general European
Regulatory rules. Check with your wireless LAN administrator or supplier
for which domain to enter in these countries.
Transmit Power
Default transmit power is Maximum. It may be set to a lower number if necessary. If
changed from the default, ensure the Transmit Power setting is the same on all
handsets and all APs.
Power is limited to 30mW in regulatory domains other than North
America.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. Site survey starts running
immediately upon selecting this option. See the
Diagnostic Tools
section for more
information about Site Survey.
Diagnostics Mode
See section 6.2
Diagnostics Mode
for a detailed explanation of the Diagnostics Mode
options.
Syslog Mode
See section 6.3
Syslog Mode
for a detailed explanation of the Syslog Mode options.