Filter
Top Products
PLANET VIP-152T User’s Manual
30
4.2. [quit] command
Type quit/exit/close will logout VIP-152T and Telnet Program.
4.3. [debug] command
This command is for engineers to debug system of VIP-152T. User can add debug flag via command
debug –add “debug flags”, and then start debug function via command debug –open. When
VIP-152T is working on screen will display related debug messages. Most frequently used debug flag
are “sip”, “fsm”, “msg”…etc.
usr/config$ debug
Debug message information and configuration
Usage:
debug [-add type1 [[type2]...]] | -open | -close | -status
-status Display the enabled debug flags.
-add Add debug flag.
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
Example:
debug -add sip msg
debug -open
usr/config$
4.4. [reboot] command
After typing commit command, type reboot to restart the VIP-152T.
Sometimes after user type reboot, on terminal screen will display: "Data modified, commit to flash rom?”
which means VIP-152T will record call history or not. (Ex. REDIAL, outgoing and incoming call data)
4.5. [pbook] command
This command is functional both in Proxy mode and Peer-to-Peer mode. In proxy mode, use speed dial
or 10 DL button will dial out e.164 number in phone book. In the other hand, in peer-to-peer mode,
VIP-152T will dial out IP address.
1. -print: display phone book data. User can print all data in phone book by command