Filter
Top Products
PLANET VIP-152T User’s Manual
7
Chapter 2
Configuring the VIP-152T through LCD
Phone menu
"
Note:
1. After any configuration has changed for the VIP-152T, user has to do reboot in the
selection “Reboot”.
2. It is suggested to setup IP address via LCD menu Network Get IP mode / IP Address /
Subnet Mask / Default GW first, then go to chapter 3 to do other configurations via web
browser. If user need to do more detail or advanced configurations, please refer to
chapter 4 and use Telnet command lines.
3. User can also try to enter web configuration via default IP address of VIP-152T:
192.168.0.1
2.1 Initialize VIP-152T
1. After VIP-152T finish initializing, it will get into standby mode:
VIP-152T
P2P
The main LCD screen would be shown above. “P2P” means the VIP-152T in Peer-to-Peer
communication mode, and “Proxy” means the VIP-152T is in Proxy Mode.
"
Note:
If VIP-152T didn’t register to Proxy server, when VIP-152T been off-hook, user will hear busy
tone instead of dial tone, also system LED indication will be blinking.
2. When VIP-152T is under peer-to-peer mode, on LCD will show “P2P” instead of “Proxy”.
VIP-152T
P2P 10:10:10 AM