Filter
Top Products
PLANET VIP-110/VIP-210 Web Configuration Guide
- 47 -
VIP to VIP
The previous section shows you how to test your VIP without modify any settings. This section
we will shows you how to connect two VIP together and make the call.
Assume that we have a second ITG, called VIP B, which is a VIP-110 with default setting as well.
Now, let’s setup its WAN IP address to another, e.g. ‘172.16.0.2’ and connect it together to VIP
A with the following three steps.
Step 1.
On VIP B:
ITG>
net set wan ip 172.16.0.2
ITG>net store
ITG>net reset
<
confirm prompt and restart machine>.
Step 2.
Connect WAN port of VIP A and VIP B to the same switch or hub, please make sure the
connection is ready.
Step 3.
On VIP A:
ITG>ping 172.16.0.2 ; ping to VIP B
Ping 172.16.0.2 success
1 out of 1 pings succeeded.
VIP B:
ITG>ping 172.16.0.1 ; ping to VIP A
Ping 172.16.0.1 success
1 out of 1 pings succeeded.
After the three steps, this means both VIP can find each other.
Now let’s setup a remote H.323 gateway to each other.
Dialplan setting on VIP A:
You can
also check LED indicators on VIP for telephony port
status. When an incoming call reaches VIP, the related LED
should flash. And after picking up the handset, it should
remains on and goes off after the phone is onhook.
i
Hint