Filter
Top Products
PLANET VIP-110/VIP-210 Web Configuration Guide
- 9 -
If you cannot get any response from the terminal program
after strike “Enter” key several times.
Please check the
TCP/IP configurations of your computer, i.e. the des-
tination VIP should be reachable
by your PC. Then check the
pa
rameters above again. If all the network parameters are
correctly configured, it is recommended to check if the
network cabling is secure.
ITG>net set lan
net set lan ip <addr>
net set lan mask <mask>
ITG>
LAN/WAN Interface quick configurations
Nature of PLANET VIP-110/VIP-210 is an IP Sharing (NAT) device, it comes with two default IP
addresses, and default LAN side IP address is “192.168.0.1”, default WAN side IP address is
“172.16.0.1”. You may use any PC to connect to the LAN port of VIP-110/VIP-210 to start machine
administration.,
LAN IP configuration via command line interface (CLI)
Here we’d like to configure the IP address of VIP-110/VIP-210 LAN interface, LAN IP address
related commands are:
• The command “net set lan ip” is used to set the IP address of VIP. If you would like to set
up the IP address to “192.168.0.1”, for example. You can have the command as below and
press the <Enter> key:
• The command “net set lan mask” is used to set the network mask of VIP. If you would like
ë
Note
ITG>net set lan ip 192.168.0.1<enter>
In general cases, the LAN IP address is the default gateway
of LAN side workstations for Internet access, and the WAN
IP of VIP-110/VIP-
210 is the IP address for remote calling
party to connect with.
i
Hint