Philips C922 Cordless Telephone User Manual


 
4
Installation
Installation
Location
Place the charger on a flat, even surface, or attach it securely
to the wall.
Do not place the charger, handset or the accessories (refer to
page 29) in the vicinity of:
• Water, moisture or damp areas.
• Heat sources, direct sunlight or inadequately ventilated areas.
• Devices which produce strong magnetic fields, electrical
appliances, fluorescent lamps, computers, radios, TVs, fax
machines and telephone terminals.
• Areas where the equipment may be covered, its ventilation
impaired, or where fluids could penetrate into it.
Areas where there is excessive dust, and areas which are sub-
jected to vibration, shock or extreme temperature fluctuations.
Place and/or store the handset and its accessories out of the
reach of small children.
Battery
Installation/
Removal
The battery pack is installed in the back of the handset hous-
ing. Be sure to place the battery pack in the compartment from
above. (Do not attempt to slide the pack from the bottom or
side of the compartment.)
• Place the pack into the battery compartment by first position-
ing it above the guide pegs (1) as illustrated. (The lower end
of the pack should stick out approximately 1 cm over the
lower edge of the handset.)
• Slide the pack upwards into the compartment until it clicks
into place (2).
To remove the battery pack:
• Push the release button (3).
• At the same time slide the battery pack approximately 1 cm
out of the compartment.
• Lift and remove the battery pack from the handset.