Filter
Top Products
33
Mounting the
Chargers
• Remove the charger pedestals by pushing them in slightly
against the lower catch hook and then lifting them out.
• Remove the protective covers of the charge contacts of the
charger rack by pushing them apart in the direction of the
arrow (1).
Do not touch or deform the contact springs!
• Hang the chargers as shown with their hanger holes on the
bolts (2) and press them straight down until they snap into
place (do not tilt them sideways).
Desktop
Installation
If you use the charger rack on your desktop, you can use the
pedestals (3) included in the delivery and slide them into place
on the back of the rack.
Wall Installation To mount the charger racks on the wall, use the cross-recess
screws (included in the delivery). Using the drilling template
included in the delivery, mark the drill holes (6 mm diameter).
The screw heads should protrude 2-3 mm out of the dowels.
Hang the charger rack on the screws and tighten the screws
through the holes from the front.
Power
Connection
Connect the power pack (4) to the charger rack and insert it
into the socket (230 V).
Accessory
Overview:
• Carrying case with belt clip and transparent protective cover
(keys can be pressed through the cover).
•Belt clip
• H eadset
• Charger rack
• Docking station
Only use equipment and accessories approved by the supplier
of your handset. The use of any type, other than that which is
approved, invalidates your right to claim under warranty.
You can order accessories from the supplier of your handset.