Filter
Top Products
Installation 9
Installation
: "This equipment is not designed for making emergency telephony calls
when the power fails. Alternative arrangements should be made for access
to emergency services".
Choosing the location of the charging unit and base
station
Place the charging unit near a 220 V/ 240 V - 50 Hz wall socket.
In order to reduce possible interference, do not place the charging unit and the base
station at less than 50 cm from any other electronic equipment (telephone, TV set,
computer, etc.).
The charging unit and the base station can be placed on a flat surface (desk) or wall
mounted.
Do not install the charging unit:
• in a damp room,
• near a heat source,
• near obstacles, like thick walls or metallic structures.
Installing the charging unit on a level surface
• Plug the power cable into the charging unit.
• Place the charging unit on a level surface.
• Plug the power cable into a wall socket.
• Place the telephone handset on the charging unit.
: Only use the power cable supplied with the device.
Wall mounting the charging unit
• Drill two holes into the wall, with vertical spacing of 65 mm, and insert the
screws.
• Plug the power cable into the charging unit.
• Hang the charging unit on the screws.
• Plug the power cable into the wall socket.
• Place the telephone handset on the charging unit.
: Only use the power cable supplied with the device.
Installing the base station
Make sure the wall socket is connected to the correct 220 V - 240 V mains voltage.
• Plug the power cable into the connector (base station symbol ), then into the
wall socket.
• Plug the telephone cable into the connector (base station symbol
t
), then into the
telephone wall socket.
. . .
prelim-zenia.book Page 9 Mardi, 20. juin 2000 10:31 10